|
|||||
| ||||||||
These motors are common to:
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| We receive a lot of inquiries
for this style of motor. Normally the motor numbers do not cross reference, which makes it difficult to identify. We have selected the following motors, that will fit a number of these applications. Motor has 6" wire leads, no plug. |
Motor has 4 studs (#8 screw) to mount with on each end. Simply cut off the studs not needed with a hacksaw. If the shaft is too long it can be cut as well. (not hardened steel) |
||
|
|||
|
3.3" Diameter - Motor length = 2.5" - Shaft length 2.25 - Stud bolt circle = 2.85" - 115volts, 60hz. - 1500RPM |
|||
|
HP |
RPM | Amp. |
Shaft |
Shaft |
Fasco |
||
| 1/50 | 1500 | .75 | 1/4" | CW | D124 | ||
| 1/50 | 1500 | .75 | 1/4" | CCW | D125 | ||
| 1/40 | 1500 | 1.1 | 5/16" | CW | D126 | ||
| 1/40 | 1500 | 1.0 | 5/16" | CCW | D127 | ||
| ▼ Below motor length = 2 1/8" ▼ | |||||||
| 1/70 | 1500 | .7 | 1/4" | CW | D120 | ||
| 1/70 | 1500 | .7 | 1/4" | CCW | D121 | ||
 |
If you need 5/16" shaft on D120 or D121 |
||||||
| * Rotation facing the shaft - Shaft has flat
Note: Motor is not reversible We do not sell fan blades |
|||||||
|
© 1999-2010
All rights reserved Winans Inc.
|
